English
Français
EspañolA chair mold is a mold used to make a chair, usually consisting of a set of templates and a mold base. The specific steps to use the chair mold are as follows:
Prepare the mold: Take the mold out of storage, clean it and inspect it for wear or damage. Determine the formwork and formwork to use as required.
Prepare materials: According to the design and requirements of the chair mold, prepare the required materials, such as concrete or other building materials.
Install the formwork: According to the design and requirements of the mold, install the formwork at the appropriate position.
Installing the formwork: Install the required formwork onto the formwork in order and make sure they are securely fastened.
Concreting: Pour concrete or other material into the mold, making sure to fill every void well. Use a vibrator to compact the concrete and remove air bubbles.
Drying and Hardening: Let the concrete dry and harden naturally in the mold, usually from a few days to a few weeks, depending on the concrete and environmental conditions.
Removing the formwork: When the concrete is completely dry and hardened, remove the formwork and tap the mold lightly to completely release the chair from the mold.
Finish and touch-up: Clean and touch-up the chair surface to smooth it and achieve the desired look.
The above is the general usage steps of the chair mould, the specific usage methods and steps may vary according to the design and requirements of the mould. Before using the chair mould, you should understand the instructions and safety precautions in detail, and follow the relevant operating guidelines and specifications.
